The Building
People & Usage
The Small Print
This is a planning estimate, not a survey. Foil-backed insulation, steel racking, concrete, cold stores and neighbouring networks all change real coverage — sometimes dramatically. Before spending on hardware, a heatmapped WiFi survey measures your actual building and gives exact positions. Triset includes one free with any installation project.
Your Building & Users
| Area | |
| Construction | |
| Users at peak | |
| Main usage |
The Numbers
| APs needed for coverage | |
| APs needed for capacity | |
| Estimated peak demand |
Recommendation
| Access points (enterprise grade, wired backhaul) |
HOW THE NUMBERS WORK
- Coverage — how far the signal reaches. One enterprise AP reliably covers roughly 220 m² in open spaces, 130 m² in a standard office and 80 m² behind brick walls and small rooms. Floor area divided by the right figure gives the coverage count — walls, not raw square metres, are what kill WiFi.
- Capacity — how much the air can carry. Every AP shares one radio's airtime among all connected users. A modern Wi-Fi 6 AP delivers roughly 300 Mbps of real aggregate throughput in a busy cell, so the capacity count is: concurrent users × their demand ÷ 300 Mbps.
- Whichever is larger wins. A small office packed with video callers needs more APs than its floor area suggests; a huge, empty warehouse with four tablet scanners needs fewer than its size suggests. The calculator runs both checks and recommends the bigger number.
- Devices count double. Phones, laptops, printers, TVs, tills, cameras and smart plugs all connect. The calculator counts people and applies a peak-usage percentage, which is a fair proxy — but a device-heavy site should round up.
- It is still an estimate. The real answer depends on your building. A heatmapped WiFi survey replaces assumptions with measurements — and with Triset it is free with any install.
COMMON QUESTIONS
- Why does the calculator show two different AP counts? Coverage answers "is there signal everywhere?" and capacity answers "is it fast at 11am when everyone is on Teams?". Both matter; the recommended plan is whichever needs more APs.
- Can I just buy a mesh kit instead? Consumer mesh is fine for homes. In a business, each wireless hop halves throughput and roaming becomes unreliable. Enterprise APs on wired backhaul cost similar per unit and behave properly under load.
- Do walls really change the count that much? Yes — one internal block wall can cost a third of the signal; foil-backed plasterboard and steel racking are worse. That is why "dense" offices plan 80 m² per AP where open cafés plan 220 m².
- What about guest WiFi? Plan it as its own capacity bucket on a separate VLAN, so visitors can never slow (or reach) your business systems.
Triset designs and installs business WiFi UK-wide — survey, cabling, AP mounting, controller setup and post-install validation. Network installation · WiFi site surveys